 |
||||
 |
 |
 |
 |
 |
 |
||||
| NatureWall Overview, and Ideas |
NatureWall Installation Guidelines and Cross Sections |
NatureWall Planting Guide | NatureWall Downloads |
1. Install filter fabric beneath the planting cores of the blocks, fill the cores with planting soil, wrap filter fabric around back of blocks and over the top of filled cores as shown in illustration.
2. Install 1/4” drip irrigation tube in the block cable slot as shown. Place a drip emitter on the tube in each core. Test the system.
3. Place the NatureWall clips in the slots at the back of the block as shown. Install the next course of StoneWall SELECT units.
4. Place the plants in the soil-filled cores of the block.
5. Trim the planting cores with mulch, chips or stones.
NOTE: See NatureWall Installation Guidlelines and Cross Sections for more detailed information regarding installation instructions, soil conditions, wall heights, slope behind wall, and surcharge conditions.
The NatureWall Clip
in set back position thereby exposing
core filled with planting soil.
Blue circle indicates drip irrigation
installation.
Red line indicates filter fabric
wrapped around planted SWS unit.
Filter fabric placed under the SWS cores to be filled with planting soil. The 26" fabric wraps up the back and over the top of planting cores, to segregate soil from gravel backfill. NatureWall Clips placed on the blocks for setback exposing planting cores.
Two courses of StoneWall SELECT with standard clips laid above the planting course, exposing a planting pocket in the wall, as avove.
Using a planted NatureWall design to end a wall into a slope.
Using a planted NatureWall design to create a terraced section within a longer wall as similar to photo below.
|
[E-Mail: info@selecticd.com] [Phone: 800 / 394-4066, or 414 / 962-4065] [Fax: 414 / 332-9678]
[Write: 3934 North Ridgefield Circle, Milwaukee, WI 53211] If you find links and/or downloads which do not work, |
|